Liftmaster 41A5034 Garage Door Opener Safety Beam Kit

 

Liftmaster 41A5034 Garage Door Opener Safety Beam Kit

 

Product Details

• Item Weight: 3 ounces
• Shipping Weight: 6.1 ounces (View shipping rates and policies)
• ASIN: B0006OAFVE
• Item model number: 41A5034
  

By : LIFTMASTER
List Price : $49.95
Price : $16.50
You Save : $33.45 (67%)

Product Description

The 41A5034 sensors involve a pair of sensors(sending and receiving), about 12" of wire attached to each sensor, wire connectors to splice wire into existing wire, mounting screws to mount to brackets, and directions. If your opener has not had sensors, the 41A5 034 senors can not be installed to your opener.

Technical Details

• What openers are compatible with the 41a5034 sensors?
• 1. Newer Chamberlain manufactured garage openers including Sears Craftsman, Chamberlain,Liftmaster
• 2. Newer Chamberlain openers that currently have black brackets that clip onto the garage door track
• 3. Chamberlain openers that currently have 1 sensor with a green light ; sensor with a yellow light
• Compatible brackets: 41a5266-1(not included with 41a5034)

Customer Reviews

This unit was easy to install and fixed my old craftsman garage door opener model 139.53962SRT.
I learned a few tricks in the process
These are some general troubleshooting steps:
1.- Check the wiring first. Be sure wires has not been damaged. With ohm meter check for open circuit or short circuit.
2.-Disconnect the receiver and sender units. They both connect to the same terminals. Terminals 2 and 3 in my opener. Be sure to label the wires to be able to reconnect them later. Measure the voltage in the terminals. It should be around 6 volts DC. Terminal 2 negative. Terminal 3 positive. If there is no voltage the control card in the opener is defective. This kit will not help in that case.
3.- Reconnect the sender unit first. Its LED light should come on. If it does not, the sender is defective. Replace the sender.
4.- If the sender LED comes on, connect the receiver unit. The LED light comes on when it detects infrared light. Point the sender to the receiver. The receiver LED light should come on. If it does not try with a TV remote. TV remotes emit infrared light also. Point any TV remote to the receiver unit and press any button. The LED light in the receiver should light up. If it does not. The receiver is defective.
This kit includes a receiver unit, a sender unit and hardware to install.

Received kit within a week. Replaced old photo eyes with these and worked perfect. If second door fails, I'll order these again.

 

Liftmaster 41A5034 Garage Door Opener Safety Beam Kit

 

Rating: 4.5